#3 Stainless Steel Braided Hose - Designed to fit any # 3 application. Cars and Motorcycles.
To order your own custom line:
1.) Choose one of 8 steel fittings, shown in the above picture, for each end in the pulldown menu at checkout.
2.) Specify the length of dash 3 hose you desire in the pulldown menu at checkout.
3.) Specify the clocking (fitting positions in relationship to each other) you desire in the pulldown menu at checkout
4.) Choose the color PVC hose covering you desire in the pulldown menu at checkout.
Bolts and washers are not included.
NO RETURNS or REFUNDS on custom assemblies.
To insure the proper hose length; measure along the route you want your
line to run using a lightweight wire. Plan your line route so that the
lines will not get pinched. The length of the hose should be measured
from the outside edge of one fitting to the outside edge of the other,
as shown in diagram.
Clocking: Using fixed
fittings where the installation requires elbow fittings on both ends you
need to calculate the degree of angle in the relationship of the two
fittings, known as clocking. To do so lay out your assembly horizontally
and flat on a table with your left hand on the first end with the banjo
flat at 0° position, looking down on the assembly measure the angle
counter-clockwise of the fitting position in relationship to the fitting
on the other end.
Note: If you are unsure of the clocking email us a
photo or mail us a sample of the line you want to duplicate. No Returns
or Refunds on custom lines. For further instruction please see diagram
in our technical section
If you need help placing your order feel free to call us direct at 317-350-2153.