#3 Custom stainless steel braided PTFE hose with all stainless steel
fittings to fit any brake line application for cars and motorcycles.
These fittings and lines can be used in any brake line application.
To order your own custom line:
1.) Choose one of 8 stainless steel fittings, shown in the above picture, for each end in the pulldown menu at checkout.
2.) Specify the length of dash 3 hose you desire in the pulldown menu at checkout.
3.) Specify the clocking (fitting positions in relationship to each other) you desire in the pulldown menu at checkout
4.) Choose the color PVC hose covering you desire in the pulldown menu at checkout.
Bolts and washers are not included.
NO RETURNS or REFUNDS on custom assemblies.
Note: To insure the proper hose length; measure along the route you
want your line to run using a lightweight wire. Plan your line route so
that the lines will not get pinched. The length of the hose should be
measured from the outside edge of one fitting to the outside edge of the
other, as shown in diagram.
Clocking: Using fixed fittings where the installation requires elbow
fittings on both ends you need to calculate the degree of angle in the
relationship of the two fittings, known as clocking. To do so lay out
your assembly horizontally and flat on a table with your left hand on
the first end with the banjo flat at 0° position, looking down on the
assembly measure the angle counter-clockwise of the fitting position in
relationship to the fitting on the other end.
Note: If you are unsure of the clocking email us a photo or mail
us a sample of the line you want to duplicate. No Returns or Refunds on
custom lines. For further instruction please see diagram in our
technical section.
If you need help placing your order feel free to call us direct at 317-350-2153.